Symmetric and asymmetric tilt grain boundaries in Cu and Al were generated using molecular statics energy minimization in LAMMPS with in-plane grain boundary translations and an atom deletion criterion. The following ...

This paper considers the crystallographic texture evolution in a 1008 low carbon steel. The texture evolution along uniaxial, plane strain and balanced biaxial strain states were measured. For uniaxial testing, grains tend ...

High-Energy Diffraction Microscopy (HEDM) constitutes a suite of combined x-ray characterization methods, which hold the unique advantage of illuminating the microstructure and micromechanical state of a material during ...

Near-alpha titanium alloys are used for moderate-temperature applications in the early stages of the compressor in gas turbine engines. The quasi-static and fatigue properties of these alloys depend heavily on microstructure ...

Recent spherical microindentation stress-strain protocols were developed and validated on Al-6061 (DOI: 10.1186/s40192-016-0054-3). The scaling factor between the uniaxial yield strength and the indentation yield strength ...

A system design approach using an Integrated Computational Materials Engineering (ICME) was used to design three new low-cost seamless replacement coinage alloys to reduce the raw material of the current US coinage alloys. ...

A computational framework is proposed that enables the integration of experimental and computational data, a variety of user-selected models, and a computer algorithm to direct a design optimization. To demonstrate this ...

We present a new microstructure informatics dataset consisting of ultrahigh carbon steel (UHCS) micrographs taken over a range of length scales under systematically varied heat treatments. Using the UHCS dataset as a case ...