Browsing TMS Springer Integrating Materials and Manufacturing Innovation (IMMI) by Title
Now showing items 1-11 of 11
-
3-Dimensional Reconstructions of Porosity from Laser-Welds of 304L Stainless Steel at 600W and a Variety of Travel Speeds
(2014-04-04)Porosity in linear autogenous laser welds of 304 L stainless steel has been investigated using micro-computed tomography to reveal defect content in 54 welds made with varying delivered power, travel speed and focal lens. ... -
3D microstructure reconstruction of polycrystalline nickel micro-tension test
(2013-11-01)This article describes a new approach to characterize the deformation response of polycrystalline metals using a combination of novel micro-scale experimental methodologies. An in-situ scanning electron microscope (SEM)-based ... -
Al-Cu Symmetric/Asymmetric Tilt Grain Boundary Dataset
Symmetric and asymmetric tilt grain boundaries in Cu and Al were generated using molecular statics energy minimization in LAMMPS with in-plane grain boundary translations and an atom deletion criterion. The following ... -
Combined Near and Far Field High Energy Diffraction Microscopy Dataset for Ti-7Al Tensile Specimen Elastically Loaded In Situ
(2015-12-16)High-Energy Diffraction Microscopy (HEDM) constitutes a suite of combined x-ray characterization methods, which hold the unique advantage of illuminating the microstructure and micromechanical state of a material during ... -
A computational framework for material design
(2017-08-18)A computational framework is proposed that enables the integration of experimental and computational data, a variety of user-selected models, and a computer algorithm to direct a design optimization. To demonstrate this ... -
Crystallographic Texture Evolution in 1008 Steel Sheet During Multi-axial Tensile Strain Paths
(2013-12-30)This paper considers the crystallographic texture evolution in a 1008 low carbon steel. The texture evolution along uniaxial, plane strain and balanced biaxial strain states were measured. For uniaxial testing, grains tend ... -
A Dataset for the Development, Verification and Validation of Microstructure-sensitive Process Models in Near-alpha Titanium Alloys
Near-alpha titanium alloys are used for moderate-temperature applications in the early stages of the compressor in gas turbine engines. The quasi-static and fatigue properties of these alloys depend heavily on microstructure ... -
Dictionaries for Material Properties, Compositions and Processing conditions used for Intelligent Search on Steel Related Publications
Knowledge of material properties, micro-structures, underlying material composition and manufacturing process parameters that the material has undergone is of significant interest to materials scientists and engineers. A ... -
Systems Design Approach to Low-Cost Coinage Materials
(2015-11-06)A system design approach using an Integrated Computational Materials Engineering (ICME) was used to design three new low-cost seamless replacement coinage alloys to reduce the raw material of the current US coinage alloys. ... -
Tensile and Microindentation Stress-Strain Curves of Al-6061
Recent spherical microindentation stress-strain protocols were developed and validated on Al-6061 (DOI: 10.1186/s40192-016-0054-3). The scaling factor between the uniaxial yield strength and the indentation yield strength ... -
Ultrahigh Carbon Steel Micrographs
We present a new microstructure informatics dataset consisting of ultrahigh carbon steel (UHCS) micrographs taken over a range of length scales under systematically varied heat treatments. Using the UHCS dataset as a case ...